Calibration for CAL-240

Inspection and calibration of a pull tester in the range F (nom) from 500 N to 5000 N according to the DKD-R 3-3 guideline (sequence D).

This guideline describes the calibration procedure for force measuring equipment with one direction. The reduced sequence D is carried out in a built-in position with 2 upward rows at 5 measuring points. In this method, uncertainty contributions for the inverse span (hysteresis) are set equal to "0", and the comparison precision is calculated from "a-priori knowledge" for the respective calibration object The repeatability itself is determined by the calibration.

The calibration in the tensile (pull) direction is carried out in our ISO 17025:2015 accredited calibration laboratory for the measuring range up to 5000 N on a K-BNME (force reference standard measuring machine) with reference standards of class 05 in a horizontal position. The force deflection takes place via a friction and play-free air bearing.

The lowest load level is 5 N. The calibration certificates are issued with the seal of the national accreditation company in accordance with the requirements of IATF 16949:2016 and a calibration recommendation.

The declaration of conformity is made in accordance with DAkkS 71 SD 0 025, taking into account the measurement uncertainty and a CMC of 0.1%. The device receives the DAkkS calibration mark.

Traceability according to the requirements of IATF 16949:2016 and ISO 9001:2015
Reference standard machine with load force from 5 N to 5000 N accredited according ISO 17025
Highest precision and low uncertainty (CMC < 0,1%)