Calibration of Handheld force gauge (VDI/VDE 2624 sheet 2.1) CAL-100
Verification and calibration of handheld force gauge, traceable to PTB/DKD/ILAC standards.
The VDI/VDE directive 2624 sheet 2.1 describes a calibration procedure, specified for handheld force gauges, consisting of a load cell and an indication instrument, which can be integrated in one housing or splitted in two parts, sensor and handheld amplifier. In both cases the directive regards the elements as one measuring unit.
The calibration for tensile and compression force (pull and push direction) is performed on an automated calibration stand with direct staggered mass application for forces up to 1000N.
The lowest resolution is 0,2N for force gauges with 2N measuring range. Force gauges with nominal measuring range higher 1kN are calibrated on a stand with transfer standards up to 250 kN.
Please consult the below table in order to check which measuring ranges of the calibration stands are covered by the accreditation in relation to the nominal force range of your gauge.
- Traceability according to requirements of EN ISO 9001:2008
- Calibration stands with EN ISO 17025 accredited measuring ranges from 2 N to 250 kN.
- Highest precision, low uncertainty (CMC<0,02%)
Measurement
Manufacturer
Standard
Our calibration laboratory is accredited to perform DAkkS-compliant calibrations, according to DIN EN ISO/IEC 17025.
What is a DAkkS-compliant calibration?
DAkkS-compliant calibrations are, according to the national standards of NMIs (national metrology institutes), the highest level of standard in the calibration chain.
